Analyze Picking Zeros
Analyze the picking zeros given by the operators during normal picking, i.e., stock and JIT, including complete containers picking.
During picking, when an operator gives a zero, i.e., when not all merchandise is picked by the requested quantity, WPMS logs that information, so it can be analyzed on a new report located on
Application → Warehouse Managment → Goods Issue → Inquery → Analysis Picking Zeros (AL382).
This new report should display several info’s such as the article, quantity requested, quantity not picked, picked quantity, operator, final site, container, work unit (if available), etc.
Picking Complete Containers
On the following image there is a traditional report to pick a complete container. In this case the operator will give a zero, so the WPMS will log that zero, so it can be analyzed afterwards on the new report.
The action is registered and it can be seen and analyzed on the new report.
Application → Warehouse Managment → Goods Issue → Inquery → Analysis Picking Zeros (AL382)
In the following example on normal picking, when the article is picked with partial quantities (if it is defined on work unit type to allow partial quantities), that will not be registered as a given zero and the remaining quantity will be requested on a new report action, as usual.
Only at this point, if the operator gives a zero, then the action is registered as a given zero, and it can be analyzed immediately on AL382.
This new log will also work on back picking work units, because the main reason to register this type of situation is to pick less than requested, so this feature also predicts back picking zeros.
In the example above, the operator decide to pick the article in teh end of the work unit, so he chooses back picking feature. After all articles picked, the article chosen to be in the back picking pops up.
Once again only at this point, if the operator gives a zero, then the action is registered as a given zero, and it can be analyzed immediately on AL382.